How To Install Shower Pan Liner On Concrete

Before Troweling The Pan I Put Small Pebbles Around The Weep Holes In The Drain.

It will be the consistency of wet sand, but not plastic like concrete. My question is how to handle the waterproofing interface between my sump and the bathroom floor level (like where the curb. Once in position, carefully take a utility knife and cut x's on the heads of each of the 4 bolts and slide the liner over the bolts.

1) The Metal Lath Or Reinforcement Can Be Placed Over A Cleavage Membrane On Top Of The Subfloor.

Position the liner in the shower pan over your preslope floor and up the walls. This method can be used to build a pre slope or pre pitch for a vinyl liner, or the base for a s. So if your shower pan is 3′ x 3′ buy a liner that is 4′ x 4′.

85Mm Down From The Underside Of The Tray Together With A Channel To Accommodate The Waste Pipe.

It will never come into contact with the pan liner. I would install a single 2×4 for a curb. Fit the shower tray over the bed of adhesive and firm down ensuring the tray is level in all planes identify the position of the drain and trap and remove any existing concrete to a depth of approx.

Another Problem With A Curbess Shower Is The Rubber Under The Door Will Drag The Bath Floor Everytime You Open And Close It.

At the corners, do not cut the sheet, but rather fold the corners tightly and neatly and secure the flap with plenty of staples. This type of floor must be graded slightly toward the center drain. I adjusted the height of the drain top above the vinyl to get about 3/4 of mud plus the thickness of the tile used.

Continue Slowly Adding Water Bit By Bit Until All The Drypack Concrete Mix Is Just Barely Wetted.

Go slow for the first couple tries though. Use a drill to drill holes into the wall where the screws will be inserted. Home advisor recommends waiting at least 24 hours for the concrete to dry before moving on to.