Skip to content

How To Replace Dryer Belt Maytag 2021

How To Replace Dryer Belt Maytag 2021. Once the wire is no longer attached, unthread the screws securing the assembly to the back of your dryer. While holding the drum in place, lift out the bulkhead and set it aside.

Howto replace a broken dryer belt on a Whirlpool Dryer. By Howto Bob from www.youtube.com

How to change belt on maytag dryer. The flat side of the dryer belt should be against drum. Remove power, pull washer out from the wall, tilt washer against the wall to replace the belts.

If The Old Dryer Belt Is Still Attached, You Will Need To Slide It Off The Drum So The Drum Can Be Removed, Or Cut It And Simply Pull It Out.

Once the wire is no longer attached, unthread the screws securing the assembly to the back of your dryer. That gives advice or instruction on a particular topic; While holding the drum in place, lift out the bulkhead and set it aside.

Which Side Of Dryer Belt Goes Down?

Stand up and open your dryer door, and unthread the screws holding the main front panel to the lint screen housing. How to replace dryer belt for maytag mde308dayw will not tumble ap6009126 step by step instructions on how to replace a dryer belt for maytag mde308dayw will not tumble ap6009126 note this video is intended to give you the general idea of the part replacement procedure your appliance may differ depending. Unthread the old belt from the pulley and motor shaft and pull the belt out.

I Believe Your Dryer Has The Small Idler Pulley.

Remove the 2 screws at the base of the front of the machine first. The new belt should have a picture for proper installation. If the tub agitator on your machine stops working but the motor keeps running, the drive belt is either slipping or broken.

Unscrew The Three Control Console Screws.

Next, disconnect the heating element wire from the heating element assembly. Then remove the rear access panel and remove the tension on the belt. Now you are ready to slide the dryer drum out of the dryer housing.

This Video From Sears Partsdirect Shows How To Replace A Broken Drive Belt In Some Maytag Electric Dryers.

Top and console parts in stock and ready to ship today. Disconnect the wiring harness from the lid switch wires by separating the white clip that attaches them together. Get the drum out, clean the dryer, oil the wheels and rollers.

Leave a Reply

Your email address will not be published.